Raydafon PTO drive shafts are high-performance power transmission components designed for agricultural and industrial applications. Engineered with precision-machined steel tubing and reinforced splines, Raydafon shafts deliver reliable torque transfer between tractors and implements like mowers, balers, and pumps. Key features include telescoping adjustability, corrosion-resistant coatings, and OSHA-compliant safety shields for maximum durability and operator protection.
To cut a PTO (Power Take-Off) drive shaft, first measure and mark the desired length. Use a high-speed grinder or reciprocating saw for clean cuts. Ensure the shaft remains balanced by cutting equal amounts from both ends if possible. Deburr the edges and verify fitment before reattaching. Always follow manufacturer guidelines to avoid compromising strength.
Measure a PTO drive shaft by determining its total length (end-to-end) and spline size. Use calipers for spline width/depth or match existing splines to standard sizes (e.g., 1-3/8" or 1-3/4"). Note the shaft’s outer diameter and connection type (e.g., yoke or collar) for compatibility with your equipment.
PTO shaft length is measured from end to end in a straight line (not collapsed). For telescoping shafts, extend fully to measure maximum length, then retract to check minimum. Ensure the shaft is 10–15% shorter than the maximum distance between tractor and implement to avoid overextension.
Shorten a PTO shaft by cutting the outer tubing (not the inner splined shaft) to maintain structural integrity. Mark the excess length, cut evenly on both sides (if applicable), and reattach safety shields. Test the shaft at low RPMs afterward to ensure smooth operation.
A PTO drive shaft transfers power from a tractor’s Power Take-Off (PTO) to implements like mowers or tillers. It consists of telescoping steel tubes with splined ends for flexibility and torque transmission. Standard PTO shafts rotate at 540 or 1,000 RPM and include safety shields to prevent entanglement.